Threading The Upper Looper - Janome 9200D Livret D'instructions

7
1
(A)
1
2
36
1
2
3
6
4
5
(B)
2

• Threading the Upper Looper

Place a spool of thread on the spool pin second from
the right.
The points to thread for upper looper are marked
*
in red.
A convenient threading chart is placed on the
*
machine body inside the looper cover.
1. Draw the thread through the thread guide second
from the right from back to front: (A)
If the thread is coming out from the thread guide
*
groove, pass the thread through the thread guide
hole again as shown: (B)
1
Thread guide
2. Pass the thread through the holes in the second
row from the right of thread guide plate as
illustrated.
2
Thread guide plate
4 3 2 1