Threading The Lower Looper - Janome 9200D Livret D'instructions

10
9
8
(A)
1
2
30
2
3
4
5
6
7
1
(B)
2

• Threading the Lower Looper

Open the looper cover and side cover.
1
Place the spool of thread on the right side spool pin.
The points to thread for lower looper are marked
*
in green.
A convenient threading chart is placed on the
*
machine body inside the looper cover.
1. Draw the thread through the right side thread
guide from back to front: (A)
If the thread is coming out from the thread guide
*
groove, pass the thread through the thread guide
hole again as shown: (B)
1
Thread guide
2. Pass the thread through the holes on the right side
of the thread guide plate as illustrated.
2
Thread guide plate
4 3 2 1