Russell Hobbs 18553-56 Mode D'emploi page 4

C THE SPLASH GUARD
10 Switch off, unplug, and raise the arm before fitting/removing the splash guard.
11 The splash guard fits over the end of the drive shaft and drive:
a) Align the latches on the splash guard with those on the drive.
b) Turn the splash guard 3cm clockwise.
c) Lift the splash guard towards the drive.
d) Turn the splash guard 3cm anti-clockwise.
e) This should engage the latches on the splash guard with those on the drive.
12 To remove the splash guard:
f) Turn the splash guard 3cm clockwise.
g) Move the splash guard down, away from the drive.
C THE LID
13 Open the lid to add ingredients, close it again, to avoid splashing.
C THE BOWL
14 Raise the arm before fitting or removing the bowl.
15 Fit the bowl to the appliance and turn it clockwise.
16 Turn it anti-clockwise to release it.
17 The contents of the bowl will rise when you start the motor – the higher the speed, the more
they'll rise.
18 Try not to fill the bowl more than about half full (specially when using the whisk).
, Use only the bowl supplied.
C THE ATTACHMENTS
19 Fit and remove the attachments with the appliance switched off and unplugged, and the
arm raised.
20 Align the slot in the top of the attachment with the lug on the drive shaft, push the
attachment on to the drive shaft, and turn it clockwise.
21 To remove an attachment, push it on to the drive shaft, turn it anti-clockwise, then pull it off.
22 Lower the arm.
a) Check that the appliance is switched off (0).
b) Hold the bottom of the appliance.
c) Turn the arm release to U.
d) Press the arm down.
e) Let the arm release go.
f) Let go.
C WHICH SPEED?
attachment speed
4-10 + Y
whisk
beater
hook
N USING THE BLENDER
23 Put a hand on top of the rear drive cover and twist anti-clockwise, to release it and expose
the drive for the jug.
24 Align the spout with the speed control.
25 Lower the jug on to the drive.
26 Turn the jug clockwise till the latches under the jug base engage with the drive, then push
down and keep turning till it locks into place.
27 Put the ingredients into the jug.
28 Don't fill past the 1.0l mark. If you do, the contents may force the lid off when you start the
motor.
use
beating/aerating cream, egg whites, batter, light mixes
4-6 creaming butter and sugar, medium cake mixes
1-3 heavy mixtures, bread, pastry
4