BIG ASS FANS es6 Mode D'emploi page 7

3. Install uplight (optional) (cont.)
Skip this step if you are not installing the uplight.
Align rectangular cutouts in center of uplight with bolts on downrod. Make sure uplight
wiring harness and motor unit wiring harness are on opposite sides of downrod. This will
make the harnesses easier to connect. Slide uplight down the downrod, resting it on the
fan hub (Fig. 3.2).
Fig. 3.2
WARNING: Skin or eye damage may result from directly viewing ultraviolet
light produced by the lamp in this apparatus. Always disconnect power before
relamping or servicing. Replace ultraviolet LEDs with Model No. 1050-45-50,
manufactured by Big Ass Fans.
© 2021 DELTA T LLC Ι ALL RIGHTS RESERVED.
3