Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE AND CLEANING
WARNING: Risk of fire, electric shock, or injury to persons during cleaning and
user maintenance. Disconnect the appliance from the power supply before
servicing.
WARNING: Skin or eye damage may result from directly viewing ultraviolet
light produced by the lamp in this apparatus. Always disconnect power before
relamping or servicing.
Please take a few moments each year to perform the following preventative
maintenance procedures on your fan to ensure its safe and efficient operation.
Checking the safety cable
Check that the safety cable is properly installed by removing the canopy screws, sliding
the canopy down the downrod, and examining the safety cable and hardware.
Checking the hardware
Make sure the mounting hardware and the screws securing the airfoils to the fan hub
are securely fastened. Tighten the six airfoil screws on the bottom of the fan according
to the numbered sequence. When finished, repeat the tightening sequence.
Checking the wiring
Make sure the wire connectors are secure and the ground wires are securely
connected.
Cleaning the airfoils
Dust the airfoils regularly. If the fan becomes dirty, clean it with a damp cloth and
ordinary soap and water. Do not use solvents, gasoline, or any other chemical cleaners!
These may cause surface distortion and damage to the fan.
Cleaning the uplight
Clean the LEDs periodically to ensure optimal performance. Use a compressed air
duster to remove dust and debris from the LEDs. Do not touch the LEDs while cleaning.
Hold the duster can upright when using.
© 2021 DELTA T LLC Ι ALL RIGHTS RESERVED.
15
Publicité
