BIG ASS FANS es6 Mode D'emploi page 5

INSTALLATION
1. Install downrod
Align holes on downrod with holes on motor bracket. Secure downrod with the
M6 x 32 mm bolt and M6 nut (Fig. 1.1). If you are installing the optional uplight, make sure
the downrod wiring harness and the motor unit wiring harness are on opposite sides of
the downrod. This will make the harnesses easier to connect to the uplight.
Fig. 1.1
M6 x 32 mm Bolt
If you are NOT installing the uplight, connect downrod wiring harness to motor unit
wiring harness (Fig. 1.2). If you are installing the uplight, do not connect the downrod
wiring harness.
Fig. 1.2
© 2021 DELTA T LLC Ι ALL RIGHTS RESERVED.
Motor Unit
Wiring Harness
M6 Nut
Downrod Wiring
Harness
Downrod Wiring Harness
(connect only if NOT
installing uplight)
Motor Unit Wiring
Harness
1