Steinbach Poolrunner Battery+ Notice Originale page 23

Attaching the floating handle
Attach the floating handle so you can place the device in the pool and take it out of the pool in a
controlled manner.
1. Guide the end of the nylon cord of the floating
handle through the eyelet on the top part
6
.
2
2. Shorten the nylon cord to a length that roughly
corresponds to the depth of your pool and tie it
in a knot.
The floating handle is attached.
Installing the brush
The brush can improve the cleaning of your pool, depending on the conditions on site, such as type
5
and quantity of dirt or surface structure of the bottom. Only operate the device with the brush installed if
this leads to a better cleaning result.
1. Press the brush strip
the bottom of the bottom part
2. Make sure that the brush strip
completely engaged and fits tightly.
The brush is installed.
Removing the brush
1. Unlatch the hook of the brush strip
part at the same time.
4
2. Take out the brush strip
The brush is removed.
Operation
Do not operate while swimming! Mortal danger!
Hair or clothing can be sucked in or trapped by the cleaning element, hold persons under
water and, in extreme cases, prevent them from resurfacing.
- Never operate the device while there are persons in the pool.
- Prevent any access to the pool as long as the device is in operation.
into the indentation on
5
.
4
has
5
from the inside and press the brush strip out of the bottom
5
.
5
WARNING!
4
6
2
5
4
5
23