Initiation; Scope Of Application; Installation; Operation - Intimus 34 CP7 Instructions D'opération

GB
2

Initiation

2 .1 Scope of application

Caution!
Damage to the cutting mechanism!
The machine must only be used to shred
paper .
Shredding other sorts of data carriers may
cause damage to the machine (e.g. damage
to the cutters etc.).
The intimus 34 CP7 data shredder is a machine used
for shredding general documents.

2 .2 Installation

1 . The shredder should be placed on a flat level sur-
face.
2 . Make sure that the wastebasket is completely in-
serted into the shredder cabinet and that it fits
flush with in the cabinet.
3 . Plug the power cord into any standard 230-volt AC
outlet.
4 . Depress the ON/OFF button (Fig. 1/1). The READY
LED (Fig. 1/2) should light up. You are now ready to
start shredding.
NOTE!
UK adaptor is inside of basket!
3

Operation

Caution!
Damage to the machine!
Do not attempt to operate shredder if the
shredder is experiencing any kind of problem.

3 .1 Turning the machine on

With the electrical cord plugged in, with the ON/OFF
button (Fig. 1/1) depressed, and with the shredder
wastebasket properly in place, the READY LED (Fig. 1/2)
will light up. This means that the shredder is now ready
for operation.

3 .2 Operating the shredder

NOTE!
Remove all paper clips and staples from paper
before shredding.
When paper is inserted into the feed opening, the
shredding process will start automatically and stop
8
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
when the paper has completed its travel through the
feed opening.
1
2
3
4
5
1 ON/OFF button
2
Ready LED
3 Overheat LED
4 Overload LED
5
Bin Full LED
6
REVERSE button
7 FORWARD button
8
Feed opening
Fig. 1 Controls intimus 34 CP7
The ON/OFF button (Fig. 1/1) is located on the top of
the shredder. Also located on top of the shredder is the
FORWARD and REVERSE buttons (Fig. 1/7+6).
Controls:
„ When the ON/OFF button (Fig. 1/1) is pressed, the
shredding process will start when paper is inserted
into the feed opening and will continue until it has
passed through the feed opening.
„ The REVERSE« button (Fig. 1/6) is used to assist
in the removal of a paper jam, which reverses the
shredding process prior to a completed forward
cycle, thus clearing the cutters. When switching
from REVERSE to FORWARD, always allow the mo-
tor to stop to prevent possible damage to the mo-
tor.
„ The ON/OFF position (Fig. 1/1) is used to termina-
te the AC power to the shredder. lt is recommen-
ded to turn the shredder off when the shredder is
not being used for a prolonged period of time.
„ When the READY LED (Fig. 1/2) is lit, it lets the user
know that the wastebasket is inserted correctly
and that the shredder is turned on and ready for
use. lf the READY LED does not light up, make sure
that the plug is plugged in, the basket is inserted
correctly and the ON/OFF is depressed.
„ When the overheat LED (Fig. 1/3) is lit, turn off
or unplug the power cord from the AC outlet and
wait at least 30 minutes . This will allow the motor
to cool down.
6
7
8
000186
94651 1 11/17