Scheppach DP19Vario Traduction Des Instructions D'origine page 36

The drill blocks the workpiece.
Excessive run and wobbling of the
drill
36 | GB
Workpiece and drill are tilted or
speed is too high.
Inadequate V-belt tension
Bent drill.
Excessive wear on the spindle
bearings.
The drill is not centred in the chuck.
Chuck is not firmly fixed.
www.scheppach.com
Reline the workpiece or fix it. See
also "Position the workpiece"
Set the V-belt tension. See also
"Setting of the speed and V-belt
tension".
Use a straight drill.
Replace the spindle bearing.
Check the centering. See also
"Setting the drill"
Correctly fix the chuck. See also
"Installing the drill chuck"