F- Maintenance; G- Technical Assistance - SCS Sentinel HWAY MCO0093 Notice D'utilisation Et D'installation

F- MAINTENANCE

F- MAINTENANCE
Conduct the following operations at least every 6 months. If in high intensity of use, shorten the period in between.
Disconnect the power supply:
(1) Clean and lubricate the screws, the pins, and the hinge with grease.
(2) Check the fastening points are properly tightened.
(3) Make the wire connection are in good condition.
Connect the power supply:
(1) Check the power adjustments.
(2) Check the function of the manual release.
(3) Check the function of photocells or other safety device.

G- TECHNICAL ASSISTANCE

G- TECHNICAL ASSISTANCE
G1- Troubleshooting
Problem
The gate doesn't move when
pressing the button of the
transmitter
The gate opens but doesn't close
The gate doesn't open entirely
The photocells don't work
The remote control is not connected Check the batteries tension. Check the antenna wiring and that the
The Wi-Fi module does not fit
If adding the Wi-Fi module fails
I am unable to register the Wi-Fi
module in the app
42 EN
1. Check if the power is higher than 22v
2. Ensure you all the wirings are well connected on the terminal block
3. Ensure you the good condition of the fuse or circuit breaker of your
supply
Check if the LED1 indication is turned on in which case check the
photocells, their connections and their aligning. Put the program H-0 for
the photocells to be inactive during the check of your connections.
Increase the power with the program 7 (setting from 7-1 to 7-6). Update
the phases of slowdown with the program 6 (settings from 6-1 to 6-4).
However on windy day, stops can be contasted since the automation
kit is subjected to anti-pinch and crushing safety norms (but it's not a
defect of the device).
Check the photocells are activated with the H : H1 program. Check the
red LED of the RX photocell is not turned. If it is the case, there is a
aligning defect of your photocells.
unifying core of the cable does not touch the braid.
1. Make sure the Wi-Fi network is 2.4 GHz.
2. Reset the Wi-Fi module :
- Press during 5 seconds on P button
- Disconnect and reconnect the module
- Check your Wi-Fi connection
- When typing the Wi-Fi password, do not type spaces
- Check that you have entered the Wi-Fi password
- Check that your box is connected to internet
- Check that your smartphone is on the same network as the one
entered in the app
- Check that the antenna is screwed in before installation
Use your smatphone with «Hotspot» mode if you lack wifi
Solutions
coverage.