SCS Sentinel HWAY MCO0093 Notice D'utilisation Et D'installation page 36

D5- System learning process, reset process and LED display
: The remote control memory storing operation must be over before starting the final system learning
process.
(1) To complete the system learning process, disengage your gate and remove it in the middle. Then re-
engage it again.
Step 1 : Press the button « SET », then « SET » + « DOWN » during 3 seconds, the LED display shows « LE »
(Pictures 1,2 and 3, see following page)
Step 2 : Press the button on the top left of your remote control during 1 to 3 seconds, the LED display shows
then « LP » (Pictures 4 and 5)
Step 3 : The gate goes to auto-learning. It means it closes a first time then opens and closes again. Please
wait for the learning process to be completed.
If your gate is opening when you start the programmation, stop the program to push on SET. «-L» appears
LED1
on the display, wait for it to turn off then go on the program 1 to reverse the rotation direction of your gate.
LED2
LED1
LED3
LED2
LED3
1
1
ON
4
OFF
4
LED1
(2)To reset factory settings.
LED2
Press UP and DOWN for 3 seconds, and the LED display shows « CL ». LED3
LED1
LED2
LED3
Appuyer
1
3 secondes
1
36 EN
Push
Appuyer
Appuyer
2
Appuyer
Push 1-3 ON
1~3 Sec
ON
sec
Appuyer
OFF
1~3 Sec
OFF
5
Appuyer
Push 1-3
3 secondes
sec
2
Push 3
Appuyer
3 Sec sec
Appuyer
3 Sec
2
3
ON
OFF
5
6
2
3
6