SCS Sentinel HWAY MCO0093 Notice D'utilisation Et D'installation page 37

LED Display
D6- Programmable function settings
To enter in the settings, maintain the button SET 5 seconds. A «1» appears. Scroll with UP or DOWN until the
wanted function, then SET to enter in this function. Then, modify the value with UP or DOWN (Be carefull, if no
button is pressed for 5 seconds, the display goes out of the automatic settings mode).
LED
Definition
viewer
Options of Gate
1
opening direction
2 Automatic closing
« -L » : the system learning is not done
« OP » : the system is in normal operation
To program, press SET button for 3 seconds. When the LED display changes from «
OP » to « 1 », press UP or DOWN to change the function settings (1 to P). Then press
SET to enter the sub function within each group, press UP or DOWN to select sub
functions and press SET to valid
« LE » : Enter the learning mode and then wait for learning instructions.
« LP » : the system learning is in process.
The auto-learning process of gate moving :
«Gate open to the end - stop close to the end - stop»
« CL » : Reset factory setting.
Function
1-1
1-2
2-0
2-1
2-2
2-3
2-4
2-5
2-6
2-7
2-8
Programmable functions
Value
Clockwise opening
The function can adjust the direction
of gate opening. The factory setting
Counterclockwise
is « 1-1 ».
opening
No automatic
This function allows to adjust the
closing
gate closing automatic after the
paused time.
5 seconds
The factory setting is « 2-0 » : no
15 seconds
automatic closing.
A simultaneous press on the two
30 seconds
buttons at the top of the remote
45 seconds
control (gate open or closed) will
60 seconds
deactivate the automatic mode
(confirmation with 3 flashing lights).
80 seconds
Repeat the operation to reactivate
120 seconds
the automatic mode (confirmation
with 3 flashing lights).
180 seconds
Description
EN
37