Publicité
Les langues disponibles
Les langues disponibles
TFA_No. 60.2562.01GB_Anleitung
18.08.2021
BOXX2 – Radio-controlled alarm clock with indoor climate
B: Buttons (Fig. 2-4):
B 1:
SNOOZE/LIGHT button
▲ button
B 3:
B 5:
ALARM button
B 7:
ALARM 2 switch
B 9:
POWER ON/OFF switch
C: Housing (Fig. 2+4):
C 1:
Light sensor
C 3:
LED light
6. Charging
• The battery symbol appears when the battery needs to be charged (capacity ≤15%).
• Please charge the device immediately to preserve battery life.
• Insert the supplied USB cable with the micro-USB plug into the provided opening on the device. Connect the device via
the USB cable only to a suitable USB power source.
• Do not apply excessive force when connecting the USB cable. The USB plug fits only one way into the USB port.
• To fully charge, leave the device connected for approximately 4 hours.
16:57 Uhr
Seite 18
B 2:
SET button
▼ button
B 4:
B 6:
ALARM 1 switch
B 8:
ALARM-MODE switch
B 10: AUTO LIGHT ON/OFF switch
C 2:
USB 5V port
– 34 –
BOXX2 – Radio-controlled alarm clock with indoor climate
• The LED light indicates that the built-in rechargeable battery is charging. Once the light is off, the built-in rechargeable
battery is charged.
• Disconnect the device from the charging power source.
• Do not leave the fully-charged device connected to the charging power source as this may shorten battery life.
• Recharge the battery every six months, even if the product is not in use.
7. Getting started
• Before the first use, please charge it fully.
• Slide the POWER ON/OFF switch to ON.
• The device will alert you with a beep and all segments will be displayed for a short moment.
• The backlight turns on for a short period.
7.1 Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol flashes on the display. When the time code is suc-
cessfully received after 3-7 minutes, the radio-controlled time, the date, the current day of the week and the DCF symbol
will be shown steadily on the display.
• You can also start the initialization manually.
• Press and hold the ▼ button for 3 seconds.
• The DCF reception symbol will be flashing.
– 35 –
Publicité
