Troubleshooting
PROBLEM
No carbonation.
Slight carbonation.
It is difficult to remove the water
bottle from the carbonating unit
after carbonating.
Flavor is weak or too strong.
*Under License
840241502 ENv06.indd 7
PROBABLE CAUSE/SOLUTION
• Check if CO
Carbonator* is empty. Use a brand new Carbonator*.
2
• Carbonator* is too cold. Wait until Carbonator* reaches room temperature.
• Water is too warm. Use 33°–42°F (0.5°–5.5°C) very cold water.
• Check to see if CO
Carbonator* is properly installed into the receptacle. If not, carbonation button
2
will not activate CO
Carbonator* to release carbonation.
2
• CO
is not mixed well with water. Allow 10 seconds after CO
2
• CO
Carbonator* is empty. Change the CO
2
• Carbonator* is too cold. Wait until Carbonator* reaches room temperature.
• Water is too warm. Use 33°–42°F (0.5°–5.5°C) very cold water.
• Press on the carbonation button for a longer period of time.
• The excess CO
has not been released. Press the pressure-release button until all of the excess CO
2
has been released.
• Be sure to use proper flavor-to-water ratio as directed. Adjust flavor amount according to taste.
is released into water to complete mixing.
2
Carbonator*.
2
2
7
5/27/14 11:05 AM