Ega Master 66549 Manuel D'instructions page 79

STEP 6
After setting parameters to Program 3 in Tightening Program (TP), then click
to save the data to the controller.
NOTE: Input "0" to the steps which are not activated.
NOTE: Program 3 was already assigned to "Seq3" previously.
STEP 7
After setting parameters to Step 3 in Tightening Step (TS), then click
the data to the controller.
NOTE: Step 3 was already assigned to "The First Step" of Program Nº.3 previously.
NOTE: After completed Step 1 to Step 7 settings above, you finished the Job Nº.1 setting.
NOTE: For the rest Jobs settings, the concept is the same as this one.
button
button to save
79