Ega Master 66549 Manuel D'instructions page 73

- Data Log: When
reports (instant archive, automatic archive).
- When
bottom of
red to ensure sufficient memory space.
- When is selected, the data will be recorded in "seconds" as set in
port will be exported below
D
Trend Setting: Time, Torque, Thread
Select one of the Time, Torque, and Thread from the pull-down menu. It will show the
graphic trend chart. (Refer to"TQC Trend Setting").
NOTE: When changing the "Trend Setting"(T/Q/C) setting, the screen of the chart will be
clear and then display again after finished a new tighten.
5. Instant data display
- Tightening Status: Display current complete status of fasten process.
- Status Count: Display current screw fastening status.
Reset: Reset "Status Count" counters.
- Job-Seq: Display current fastened tasks and work sequence.
- Torque: Display fastening torque.
- Time: Display screw fastening time.
is checked, there are two ways to automatically export Excel
is selected, any data fastened will be automatically exported to the
. When the system passes the integral time point, the form will be clea-
.
and the re-
73