Ega Master 66549 Manuel D'instructions page 52

C4
When "OK ALL disable screwdriver"&
"Gate Mode_ trigger twice", functions
C5
NS
BS
OK
When a batch is completed, LCM will
OK ALL
NG
E3
E4
52
When "OK ALL disable screwdriver"
& "Gate mode_ trigger once",
functions are on LCM will display
"C4" after a batch completed.
are on, LCM will display "C5" after a
batch completed.
When error occurs, LCM will display
"NS"
When turn on the Barcode Enable,
"BS" will be displayed before the job
is executed.
When screwdriver shut off, LCM will
display "OK"
display "OK ALL"
NG-F: Sequence incomplete
NS-F: Press Confirm/Enter for next
action.
NGQ: When output torque isn't
inside set torque range. Output
torque could be lower than"LQ"or
higher than "HQ"
NGC: When number of output shaft
rotation isn't inside set range. Nº. of
rotation could be lower than"LC"or
higher than "HC".
Sequence incomplete: 1NG-F
means sequence 1 is not completed
properly, 2NG-F means sequence 2
is not completed properly... and so
on.
Voltage-drop protection: When the
voltage of the electric screwdriver
drops instantly, the electric
screwdriver will be stopped, and
the LCM displays this symbol,
representing that the screwdriver
is currently under low-voltage
protection.
Over-temperature protection: When
the internal temperature of the
electric screwdriver is too high,
the electric screwdriver will be
stopped, and the LCM displays E4,
representing that the screwdriver is
currently under over-temperature
protection.
External GATE Signal
Trigger once +Panel Enter /External
CONFIRM
External GATE Signal
Trigger twice +Panel
Enter/External CONFIRM
Panel Enter button/
External CONFIRM
Barcode scan function
NA
NA
NA
NA
NA