Ega Master 66549 Manuel D'instructions page 68

B
Tightening Program (TP)
- Program: Program Nº.1 ~ Program Nº.99 could be selected.
- Program Name: 6 characters are available for the name including English, Chinese, and
Number).
- The First Step: Select a step Nº. for the first step of this selected program.
- The Second Step: Select a step Nº. for the second step of this selected program.
- The Third Step: Select a step Nº. for the third step of this selected program.
- The Fourth Step: Select a step Nº. for the fourth step of this selected program.
- The Fifth Step: Select a step Nº. for the fifth step of this selected program.
- OK All Alarm Time (AT): Set the time for OK All output signal duration (Sec.)
- OK One Alarm Time (OT): Set the time for OK One output signal duration (Sec.)
- NG Stop (NG): Disable the tool or not when a NG signal generated.
(OFF, The maximum NG counter 1-9)
- OK All Stop (AS): Disable the tool or not when a OK ALL signal generated.
(ON: Disable the tool, OFF)
NOTE: After clicking the
Tightening Program (TP).
NOTE: User can set "0" to specific Step to ignore executing that Step.
Example: If you set Second & Third Steps to "0" but First, Fourth and Fifth Steps are non-
zero. The controller will execute First, Fourth and Fifth Steps.
NOTE: Refer to manual for condition parameters.
68
button, the above settings will be saved to the selected