SilverCrest SBKG 40 A1 Mode D'emploi page 15

Handling and operation
Switching the headphones on/off
♦ Press the
phones. You will hear a beep and the LED
approx. 2 seconds. Afterwards, the LED
headphones are now in pairing mode.
♦ To switch off the headphones, press the
2 seconds until you hear a beep and the LED
Wearing the headphones
♦ When putting the headphones on, please note the markings "R" (right)
and "L" (left) on the inside of the adjustable headband
♦ Adjust the headband
2
earpieces
Pairing/unpairing the headphones with a Bluetooth
device
Before you can use the headphones with the Bluetooth
pair them with a compatible Bluetooth
♦ Switch on the headphones as described above to activate pairing mode.
♦ Set the Bluetooth
devices. A detailed description of how to do this can be found in the
operating manual for your Bluetooth
♦ Select the entry SBKG 40 A1 from the list of devices found on your
Bluetooth
to connect the two devices. If the pairing is successful, you will hear a
series of beeps and the LED
│ GB │ IE
■ 12
4
button for about 2 seconds to switch on the head-
1
so that it fits your head comfortably and the
cover your ears.
playback device so that it scans for Bluetooth
®
playback device and, if required, enter the code 0000
®
6
6
flashes blue and white. The
button
device.
®
playback device.
®
6
will flash blue every 5 seconds.
lights up blue for
4
again for about
6
goes out.
1
.
function, you must
®
SBKG 40 A1
®
®