Publicité
Les langues disponibles
Les langues disponibles
• Take flange D with seal E and assemble them on the burner cover
by using the self-threading screws supplied.
C
D - E
• Open the box containing the gas burner, remove it and keep the
two stickers with lot number for later use;
• Consult the user manual of the burner; and fit the burner fixing
screw onto the burner plate according to the instructions
• Secure the burner plate to the machine by using the 4xM8 screws
and the D8 x D24 washers;
• Insert the burner and fix it to the plate by tightening the nut
supplied onto the screw G;
• Be careful to correctly position the O-ring when fixing the
connection flange to the gas ramp.
L-L 248.00-SO
G
EN
• Locate the black cable with 7-pin Wieland plug running out of the
electrical panel and insert the plug into the socket H on the
burner;
H
• Remove the burner cover and adjust the air pressure switch to the
value listed in the technical specifications table of the user
manual;
• Adjust the gas pressure switch to 75% of its supply pressure
• Air pressure switch setting: 2 mbar
• Gas pressure switch setting: 75 % P
• Close the burner cover;
• Open the box containing the gas valve group and remove the valve
already secured onto a support plate
• Secure the gas valve group to the machine using the M8 and M5
screws.
• Remove flange D with seal E previously assembled on the burner
cover and insert it by sliding it on the gas delivery pipe.
D - E
• Connect the stainless steel hose to the burner, taking care to
IN
42 / 88
Publicité
