Cleaning And Maintenance; Transport; Storage; Disposal And Recycling - Scheppach WSE1000 Traduction Des Instructions D'origine

Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking „H05RR-F".
The printing of the type designation on the connection
cable is mandatory.
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 2.5 mm
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Machine data - type plate

11. Cleaning and Maintenance

Danger!
Always pull out the mains power plug before starting
any cleaning work.
Note: The welding device must be regularly serviced
and overhauled for proper function and for compliance
with the safety requirements. Improper and incorrect
operation may result in failure and damage to the de-
vice.
• Before carrying out any cleaning work on the weld-
ing device, pull the mains cable 8 out of the socket
so that the device is safely disconnected from the
power supply circuit.
• Clean the outside of the welding device and its ac-
cessories regularly. Remove dirt and dust using air,
a cleaning rag or a brush.
Note: The following kinds of maintenance work must
be performed only by suitably-qualified personnel.
• Current regulator, earthing device, internal wiring,
the welding torch coupling device and adjustment
screws should be serviced regularly. Retighten
loose screws and replace rusty screws (replace-
ment M4 x 10 screws are available at any commer-
cial hardware store).
• Regularly check the insulation resistances of the
welding device. Use the appropriate measuring de-
vice for this purpose.
.
2
www.scheppach.com
• In the event of a defect or if it is necessary to replace
parts of the device, please contact the appropriate
specialist personnel.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wear parts*: earth terminals, electrode holder
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

12. Transport

For easy transport of the welding machine, carry it over
the shoulder using the carrying strap provided or sim-
ply carry by the transport handle.

13. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging.
Cover the electric tool to protect it from dust or mois-
ture. Store the operating manual with the power tool.

14. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused
or recycled. The equipment and its accesso-
ries are made of various types of material,
such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.
GB | 29