Introduction; Layout; Scope Of Delivery; Intended Use - Scheppach WSE1000 Traduction Des Instructions D'origine

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating instructions include important instruc-
tions for the safe, proper and economic operation of
the machine, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the machine.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the machine in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work.
The machine may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
22 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Layout (Fig. A)
1. ON / OFF switch
2. Potentiometer for adjusting the welding current
3. Welding current scale
4. Indicator lamp for operation
5. Warning lamp for overheating
6. Positive quick-lock coupling
7. Negative quick-lock coupling
8. Power cable
9. Cable with electrode holder
10. Cable with ground terminal
11. Carrying strap
12. Combination wire brush with chipping hammer
13. Welding shield
14. Grip
15. Protective glass

3. Scope of delivery

• Welding machine with mains cable
• Cable with earth clamp
• Cable with electrode holder
• Welding mask
• Handle
• Protective glass
• Combination wire brush with slag hammer
• Electrodes (3x)
• Carrying strap

4. Intended use

This welding device is suitable for welding metals such
as carbon steel, alloy steel, other stainless steels, cop-
per, aluminium, titanium etc.
The product has an indicator lamp, heat protection in-
dicator and cooling fan. It is also equipped with a car-
rying strap for safe lifting and moving of the product.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
www.scheppach.com