Bresser Junior MicroSet 40x-1024x Mode D'emploi page 15

Troubleshooting
Error Solution
No recognizable • Turn on light
image • Readjust focus
Image flickers (while • If necessary, incre-
observing with ase resolution of
optional available graphics card
MicrOcular)
= Monitor refresh
rate not adequate
Make sure your microscope has a long
service life.
Clean the lens (objective and eyepiece) only with
the cloth supplied or some other soft lint-free
cloth (e.g.microfibre). Do not press hard as this
might scratch the lens.
Ask your parents to help if your microscope is
really very dirty. The cleaning cloth should be
moistened with cleaning fluid and the lens wi-
ped clean using little pressure.
Make sure your microscope is always protected
against dust and dirt. After use leave it in a warm
room to dry off. Then install the dust caps and
keep it in the case provided.
GB
15