Publicité
Les langues disponibles
Les langues disponibles
Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
There is too much condensed
water on the rear wall of the re-
frigerator.
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
Possible cause
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrapped.
You attempted to re-open the
door immediately after closing.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Wait a few seconds between
closing and re-opening of the
door.
9
Publicité
