Publicité
Les langues disponibles
Les langues disponibles
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
7.1.b - Electrical connection
-
Introduce the cable (42) of an extension
in the tear-proff hook (28) locking it as
shown in figure.
-
Connect the outlet (43) of the extension
cord (42) with the plug (16) of the ma-
chine.
-
Connect the power cord to an outlet hav-
ing minimum capacity of 10A.
WARNING:
- Make sure that the mains system is
equipped with an RCD (circuit breaker).
- Unwind the electric power cable com-
pletely before operating the appliance.
- Use an electrical extension lead only
if in perfect condition; ensure that the
section is appropriate for the appliance
power rating.
- Never let the power cable run over
sharp edges and do not tread on it.
7.1.c - Preparing the machine and
choosing the cycle (Figg. 6-9)
-
Press the switch (34).
-
Release the lever (3 Fig. 9) and lower it;
the floor squeegee (11 Fig. 9) is lowered.
-
Press down on the pedal (19 Fig. 9), re-
lease it from its coupling and lift it, the
brush (10 Fig. 9) will be lowered.
Working cycle:
-
The machine can perform 4 working cy-
cles:
Drying only cycle:
-
In order to perform the drying cycle alone,
press the switch (35). The suction unit will
activate.
Brushing only cycle:
-
To perform only the brushing cycle, press
the switch (38) to enable brush rotation.
Touch the sensor positioned on the han-
dle, to start the rotation of the brush /
brushes.
Washing, brushing cycle:
-
Press the switch (38) to enable brush
rotation, press the switch (39) to enable
water dispensing. Touch the sensor posi-
tioned on the handle, to start the rotation
of the brush / brushes and water supply.
Washing, brushing, drying cycle:
-
Press the switch (35) to start the aspira-
tor, switch (38) to enable brush rotation
and press the switch (39) to enable water
dispensing. Touch the sensor positioned
on the handle, to start the rotation of the
brush / brushes and water supply.
7.1.d - Using the machine (Fig. 1)
-
After turning the machine on and se-
lecting the cycle, the cleaning operation
starts, pushing the machine with the help
of the handle (1).
N.B.:
Pay attention to particularly delicate floors;
do not use the machine while it's stopped
and the brush rotation on.
N.B.:
The proper cleaning and drying of the floor
is done by pushing the machine forwards;
if you go backwards the machine will not
perform drying; in this phase, always lift the
wiper to avoid damaging the blades.
-
If necessary, adjust the quantity of wash-
ing water using the tap (4 Fig. 1).
7.1.e - End of use and switching off
(Figg. 6-10)
-
Once the cleaning operations have been
completed, do not shut off the machine
immediately: use switches (39) and (38)
to deactivate water dispensing and brush
rotation.
-
Lift up the brush by pressing the pedal
(19 Fig. 10) as far as it will go, fitting it in
the designated slot.
-
Continue with the aspirator inserted to
aspirate all the liquid on the floor, then
ENGLISH - 7
Publicité
