ARTROMOT S3 Mode D'emploi page 72

Subsequently the carriage reverses 5°
towards external rotation and then
moves very slowly back again to the
programmed internal rotation position
(display ). After that it attempts to
attain another 5°, moving even slower
than before (display
If a high resistance toward the additional
5° is sensed, the reverse on load function
is automatically activated and the car‑
riage moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed maximum external rota‑
tion position and restarts the internal
rotation stretch cycle.
This sequence can be repeated as often
as needed. You can stop treatment
with the STOP key; after the pro‑
grammed therapy duration, it will stop
automatically.
Default: disabled
Note!
– If a pause is programmed when you
enable the function, the carriage will
stop for the duration of the pause
each time the maximum stretching
value is attained.
– Enabling the stretching in internal
rotation function automatically
disables motor A.
The only movement performed is
internal / external rotation.
– It is not possible to combine a second
stretching function with the special
function „stretching in internal
rotation".
– During operation, the display will
show the symbol
left‑hand corner.
n Stretching in external rotation
With the special „Stretching in external
rotation" function the carriage gently
stretches the joint towards the outside.
Starting at the middle position the car‑
riage will first move to the programmed
internal rotation position and then to
the programmed external rotation
position.
).
in the upper,
68
Subsequently the carriage reverses
5° towards internal rotation and then
moves very slowly back again to the
programmed external rotation position
(display ). After that it attempts to
attain another 5°, moving even slower
than before (display
If a high resistance toward the additio‑
nal 5 ° is sensed, the reverse on load
function is automatically activated
and the carriage moves in the opposite
direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed maximum internal rotation
position and restarts the external
stretch cycle.
This sequence can be repeated as often
as needed. You can stop treatment
with the STOP key; after the program‑
med therapy duration, it will stop
automatically.
Default: disabled
Note!
– If a pause is programmed when you
enable the function, the carriage will
stop for the duration of the pause
each time the maximum stretching
value is attained.
– Enabling the stretching in external
rotation function automatically
disables motor A. The only move‑
ment performed is internal / external
rotation.
– It is not possible to combine a second
stretching function with the special
function „stretching in external
rotation".
– During operation, the display will
show the symbol
per, left‑hand corner.
Reminder:
You save the selected parameter values by
pressing the STOP key.
).
in the up‑