ARTROMOT S3 Mode D'emploi page 64

Patients with a programmed
chip card
• First complete the mechanical adjust‑
ments.
• Then insert the chip card (the patient is
not yet positioned on the CPM device).
• Press the START key: the device will
move to the starting position as speci‑
fied by the parameters stored on the
chip card and stops.
• Position the patient on the CPM device
and press the START key to initiate
therapy.
5.2 Programming
ARTROMOT®-S3 Standard
Different programming levels are provided
to program the ARTROMOT®‑S3 Standard
models.
You change between levels by pressing the
MENU key repeatedly.
The display always indicates the currently
selected level.
The following treatment values, settings
and information can be entered/viewed
on the programming unit (1):
LEVEL 1:
– Abduction
– Adduction
– Internal rotation
– External rotation
LEVEL 2:
– Pause
– Therapy timer
– Speed
– New patient
LEVEL 3:
– Reverse on load ‑ motor A
– Reverse on load ‑ motor B
– Motor A ON/OFF
– Motor B ON/OFF
LEVEL 4:
– Transport setting
– Synchronized/
non‑synchronized mode
– Total therapy time
– Service menu
Note!
• While you adjust the values, the
carriage will move to the set range.
This allows you to easily and quickly
determine the ROM where the pa‑
tient does not experience pain.
• Special functions can be programmed
and retrieved with ARTROMOT®-S3
Comfort devices (see sections 5.4
and 5.5).
• The angle entered last for the respec‑
tive direction of motion will be saved
in each case.
5.3 Treatment value details –
Standard models
• To access the programming level you
need, press the MENU key repeatedly.
• The treatment parameters are selected
with the different parameter keys.
• To change the treatment values, press
the + / – keys.
• To enable/disable a function, press the
respective parameter key again.
• To save the entered values, press the
STOP key.
60