Telecom Behnke 5 Serie Instructions page 52

Instructions for Series 5 / 10
GB
Configuration and Set-up
Code Parameter
Telephone number: Default: cf. text
21 Telephone number
22 Telephone number
Telephone numbers contain cyphers only and hold a maximum of
20 digits. When entering a telephone number, you may use the
following special characters:
*0
*1 = dial #
*2 = pause for 2 seconds
*7 1 = Activate relay
*8 x y = waiting for call answer (x = voice message played while
**0
*#
**** = Hang up (in case the relay is still activated, it will
By default, button 1 is set to dial extension 11 and button 2 is set to
dial extension 12 (cf. 3.3 default configuration in connection with
an AC14 AGFEO telephone system)
Use configuration step codes 50 to 59 to set-up the integrated voice message module. Using the
voice message module requires an additional 15 V power supply.
Reset voice message module:
50 * * * *
Performing a reset will return configuration step codes 51 to 59
to their default settings. Upon connecting a voice message module
and providing an additional 15 V power supply, all recorded voice
message will be erased and the number of long voice messages
will be set to its default setting 1.
Specify the number of long voice messages: Default setting: 1
* * * Number of long voice messages
1 = 1 message (message no. 6: 40 s)
2 = 2 messages (message no. 6: 20 s and message no. 7: 20 s)
3 = 3 messages (message no. 6: 15 s; message no. 7: 15 s and
message no. 8: 10 s)
4 = 4 messages (message no. 6: 10 s; message no. 7: 10 s;
message no. 8: 10 s
The voice message module will store up to 5 short voice-messages,
each a maximum of 4 seconds long. Additionally, the module
will store longer voice messages of up to 40 seconds. Via the
configuration steps 1 to 4, you may divide these 40 seconds into a
maximum of 4 long voice messages. The maximum amount of
52
▸ telephone number 1 (button 1)
▸
telephone number 2 (button 2)
= dial *
waiting for call to be answered and y = voice message
played after call has been answered)
= Hotline function
= Flash function (150ms)
remain activated until the activation interval has
elapsed, then the device will hang up)
and message no. 9: 10 s)
Confirmation
#
#
#
#
www.behnke-online.com