▸
Answer an incoming call
Answer an incoming call either manually by
pressing a button or automatically after the
first recognised signal.
▸
Direct call: Dial a saved telephone number by
pressing the button.
Up to two buttons may be used as direct call
buttons. The telephone number assigned
to these buttons may consist of up to 20
characters. The "pause" function is assigned
a special symbol, which may be included into
the saved telephone number. The amount of
time for the direct call button to be pressed
can be adjusted. By default, a short touch is
sufficient to start a direct call. Use the option
"input delay for direct call buttons" to set the
minimal amount of time for activation of a
direct call button to values between 0 and 9
seconds.
www.behnke-online.com
Instructions for Series 5 / 10
▸
Control functions: automatic or
manual relay activation
The built-in relay enables a variety of control
functions. The operating mode may be
adjusted accordingly. To trigger the relay,
please enter the activation code followed
by the # key. During a connected call, the
activation code may be entered remotely
using a telephone with DTMF dialling. A
maximum of two four-digit activation codes
may be saved. The activation interval may
be set to values between 1 and 30 seconds.
The connection will be terminated after the
relay has been activated, if desired. Upon
establishing connection the activation
interval may be set to values from 1 to 30
seconds.
GB
Introduction
41