c. After 30 minutes, your coffee maker will brew the remainder of the
cleaning solution.
d. When complete, the clean "Limpiar" light will turn off and your coffee
maker will turn off.
6. Discard the cleaning solution and rinse the thermal carafe thoroughly with
clean water.
7. Fill the water reservoir with clean, fresh water.
8. Place the empty thermal carafe back on the coffee maker.
9. Remove and discard the paper filter used during the cleaning cycle. If the
permanent was used during cleaning, remove it and rinse it thoroughly
before replacing it in the filter basket.
10. Begin brewing and allow the full brew cycle to complete.
11. Repeat steps 5 through 9 one more time.
Your coffee maker is now clean and ready to brew the next pot of delicious, hot
coffee!
Suggested Decalcifying Interval
Type of Water
Soft Water
Hard Water
Water Filtration Disk Replacement
Your water filtration disk will need to be replaced once a month (approx. 30 brew
cycles). If the unit will not be in use for an extended period of time, rinse the
water filter with running water and clean the coffee maker before use.
Cleaning the Thermal Carafe
Hard water can leave a whitish stain inside the thermal carafe, and coffee may
then turn this stain brown.
To remove thermal carafe stains:
1. Fill the carafe with a solution of equal parts water and vinegar and let the
solution stand in it for approximately 20 minutes.
2. Discard the solution, then wash and rinse the thermal carafe.
DO NOT use harsh abrasive cleaners that may scratch the thermal carafe.
Cleaning Frequency
Every 80 Brew Cycles
Every 40 Brew Cycles
or when red light is flashing
English-10