Cleaning And Maintaining Your Coffeemaker - Oster 4281 Mode D'emploi

!
C L E A N I N G A N D M A I N T A I N I N G
Y O U R C O F F E E M A K E R
Daily Cleaning
Always unplug the coffeemaker and allow to cool before cleaning.
Remove the filter basket, permanent filter, decanter and decanter lid and wash
them in a solution of hot water and mild liquid soap.
Never use abrasive cleansers, steel wool pads or other abrasive materials.
Dishwasher top rack safe parts: glass decanter and lid, filter basket, permanent
filter and stainless steel shower head.
CAUTION! Never immerse the coffeemaker itself in water, in any other
liquid or place in the dishwasher.
Regular Cleaning and Maintenance
Decalcifying your Oster coffeemaker
Minerals (calcium/limestone) found in water will leave deposits in your
coffeemaker and will affect its performance. It's recommended that you
regularly remove these deposits by using coffeemaker cleaner or vinegar.
1 Follow package instructions to prepare one batch of Coffeemaker Cleaner.
Pour the mixture into the water reservoir.
4281_Coffee_IM.qxd:manual 3/11/09
NOTE: 600ml. of undiluted, white
household vinegar may be used
as a substitute for the cleaner.
2 Place an empty cone style paper ®
filter or permanent filter into the
filter basket and close.
3 Place the empty decanter back
on the warming plate.
Press the CLEAN button . The light behind the button will illuminate. For your
convenience the cleaning cycle is automatic. The entire cycle will take 45-60 minutes
to complete. During the cleaning your coffeemaker will:
1 Slow brew approx. 700ml. of cleaning solution.
2 Pause for 30 minutes (the CLEAN light will remain on to alert you that the
process is active). At the end of the pause period your coffeemaker will beep.
3 After 30 minutes, your coffeemaker will brew the remainder of the cleaning
solution.
4 When complete, the CLEAN light will turn off and your coffeemaker will
automatically beep and shut off.
5 Brew 2.8 litres of fresh, clean water through the coffeemaker at least two
times to thoroughly rinse out the coffeemaker.
10
11:15 AM Page 10
Suggested Decalcifying Interval
Type of Water Cleaning Frequency
Soft Water Every 80 Brew Cycles
Hard Water Every 40 Brew Cycles
or when display screen flashes "Clean."
Cleaning the Decanter
Hard water can leave a whitish stain on the decanter, and coffee may then turn
this stain brown.
To remove decanter stains:
1 Fill the decanter with a solution of equal parts water and vinegar and let the
solution stand in the decanter for approximately 20 minutes.
2 Discard the solution, then wash and rinse the decanter.
Do not use harsh abrasive cleaners that may scratch the decanter, scratches
may cause the decanter to break.
FITTING A REPLACEMENT PLUG FOR U.K. AND IRELAND ONLY.
If the plug is not suitable for the socket outlets in your home, it can be removed
and replaced by a plug of the correct type. For correct type and correct
installation please refer to "Installation of a plug" below.
INSTALLATION OF A PLUG – Applicable to U.K. and Ireland.
Note: If you are in any doubt about wiring and the installation of the plug.
Please contact a qualified electrician.
The wires in this mains lead are coloured as such:
GREEN & YELLOW - Earth
BROWN - Live
BLUE - Neutral
Please note that the colour of these mains wires may not
correspond with the colour markings that identify the
terminals in your plug.
Please proceed as follows:
• The wire which is coloured GREEN&YELLOW must be
connected to the terminal which is marked with the
letter E ( ) or is coloured GREEN, or GREEN&YELLOW.
• The BROWN coloured wire must be connected to the
pin terminal, which is marked with the letter L (Live) or is coloured RED.
• The BLUE coloured wire must be connected to the pin terminal which is
marked with the letter N (Neutral) or is coloured BLACK.
• DO NOT CONNECT either of these wires to the earth terminal in the plug.
The earth terminal plug is marked with the letter E (
GREEN, or GREEN&YELLOW.
Note: If a 13A 3-pin plug is fitted, it must be an ASTA approved plug,
conforming to the BS1363 standard. Replacement 3 amp fuse must
also be BSI or ASTA approved.
) or is coloured
11