Starmix haaga 677 Mode D'emploi page 46

5.7 Cleaning the sweeper
Risk of accident!
Risk of injury due to accidental starting
of the sweeper!
• The sweeper must be switched off and
disconnected from the power supply
when performing all work.
• Do not carry out any work with running
motor.
• Disconnect the sweeper from the power
source while cleaning. Disconnect the
cable from the battery.
Danger of injury!
• Wear sturdy gloves in order to avoid
cut injuries, e.g. due to glass shards,
metal or other sharp-edged materials.
CAUTION!
Damage to the sweeper due to improper
cleaning.
• Clean the sweeper to remove dust and
dirt.
• Do not use grease removers for clean-
ing.
• Do not use aggressive detergents.
• Do not clean with a high-pressure
cleaner.
• Protect bearings against moisture.
• Do not clean the disc brushes and fine
dirt sweeping roller with compressed
air. The hard air jet could damage the
bristles.
• Clean plastic parts with a damp cloth.
46
• Do not spray-clean with water or
immerse in water. Moisture will
damage the electrical components and
can lead to short circuits.
• Cleaning interval after 8 hours of oper-
ation.
1. Clean the disc brushes, fine dirt sweep-
ing roller (1) and drives with a wet
cloth.
2. Clean plastic parts with a damp cloth.
3. Clean the dust filter (3).
Recommendation: apply a thin coating
of Haaga genuine lubricant spray to the
brush drives.
3
1
3