Conceptronic CM3PVRD Manuel De L'utilisateur page 35

ENGLISH
Connecting the antenna cable(s)
The unit is equipped with a hybrid tuner. This allows you to use the unit for analog TV reception, or digital
(DVB-T) reception.
Note: When the CM3PVRD is turned on, the device will pass the signal from the tuner input to the
tuner output. If the CM3PVRD is set to standby or when it is disconnected from the power
outlet, the signal on the tuner output will decrease, which can cause a noisy image on your TV.
Tuner Output
Analog TV:
•
Disconnect the main antenna cable from your TV, and connect it to the Tuner input of the unit.
•
Connect the supplied antenna cable to the Tuner output of the unit and to the Tuner input of your TV.
Digital TV (DVB-T):
•
Connect a DVB-T antenna to the Tuner input of the unit.
•
Connect the supplied antenna cable to the Tuner output of the unit and to the Tuner input of your TV.
Connecting the Video Cable(s)
You can connect the unit in 4 different ways to your TV:
- Composite
- SCART (by using the Composite cable & Scart Adapter)
- S-Video **
- Component **
** When using S-Video or Component, only the video signal is send to your TV.
For the audio signal, use the Audio RCA Jacks on the Composite cable (Red, White), or the Coaxial
SPDIF cable.
Composite:
•
Connect the Composite cable (Yellow, Red, and White) to the corresponding AV Output jacks on the
unit.
•
Connect the other side of the Composite cable (Yellow, Red, and White) to your TV.
6. Connecting your CM3PVRD
Tuner Input
35