Dometic Air Screen FTA Instructions De Montage page 6

This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express per-
mission from the manufacturer
• Use for purposes other than those described in
this manual
Dometic reserves the right to change product
appearance and product specifications.
Using the windbreak
Before first use
Familiarize yourself with the product by carrying
out a test set up before the product is used for the
first time. Check if the scope of delivery is
complete.
Choosing a site
1. Choose a flat site for stability.
2. Choose a shaded site to avoid UV degradation
of the fabric.
3. Avoid pitching under trees as falling branches,
resin, etc. can damage the product.
4. Clear the site of sharp stones and debris.
5. Set up the windbreak with the opening facing
away from the wind.
6
Setting up the windbreak
!
CAUTION! Risk of injury and mate-
rial damage
• Do not use any type of compressor
• Only inflate the air poles into the green
A
NOTICE! Material damage
Do not open or close the zippers by
force.
I
NOTE
• The windbreak comes with general
• Drive the pegs at a 45° angle away
• Peg each guy line in-line with the seam
Keep the following tips in mind while setting up the
windbreak:
• The figures provide a general overview of the
set-up. The actual set-up will vary slightly based
on the model of windbreak.
• Get help. The set-up is easier with more people.
• Inflate the air poles from either end.
• After standing the windbreak upright, check the
corner pegs and re-peg if necessary.
• Peg the straps so that the windbreak is under
tension without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Set up the windbreak as follows:
1. To protect the windbreak from dirt and dam-
age, lay down a groundsheet or footprint
before unpacking.
2. Unpack the windbreak.
3. Separate and identify the different compo-
nents.
4445103586
designed to inflate car tires.
zone of the pressure gauge of the sup-
plied hand pump (10 psi/0.69 bar).
purpose pegs. These will be suitable
for many sites but for some types of
ground special pegs will be needed.
Ask your dealer.
from the windbreak into the ground.
it starts from.