Velleman HQ-Power VDL250MG Notice D'emploi page 4

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
• Do not add oils, perfume or any other liquid in the smoke liquid.
• The installation has to be approved by an expert before the device is taken into service.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
4. Installation
a) Lamps
Please refer to illustrations 1 to 3 on page 2.
Only fit or replace a lamp when the device is unplugged from the mains.
• Let a lamp cool down before replacing it as the temperature of a lamp can reach 700°C during
operation.
• Do not touch a halogen lamp with your bare hands. Use a cloth to insert or remove it.
• Do not install lamps with a higher wattage than that for which this device was designed.
• Replace deformed or damaged lamps with a lamp of the same type (see "Technical Specifications"):
1. Loosen the 2 screws at the front holding the vented lid and gently remove the lid.
2. Remove the old lamp and insert the new one.
3. Carefully reposition the lid and fasten the screw.
Remark: Do not operate the device when the cover is open.
b) Fuse
Please refer to illustration 4 on page 2.
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are you will need to replace the fuse as well.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder at the back with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
c) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The construction to which the device is attached should be able to support 10 times the weight of the
device for one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Set the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
Please refer to illustration 5 on page 2.
Switch the device on and off with the power plug (1). Do not operate the device continuously.
There is a switch at the back for the mirror rotation (4). The 0 position means there is no rotation, 1 is
continuous rotation and 2 is sound-activation through the built-in microphone.
The fuse holder (2) is below the power socket. In most cases changing the lamp will also mean changing
the fuse.
09.11.2010
VDL250MG
4
Rev. 01
©Velleman nv