Match The Collar Receiver And Remote Transmitter; Program The System For Two Or Three-Dog Operation - SportDOG SportTrainer SD-425E Manuel D'utilisation

STEP :: 06

MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER

To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar Receiver to work
with your existing Remote Transmitter:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin flashing as
normal. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5
times. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been matched and
will begin flashing as normal. If the Receiver Indicator Light does not flash 5 times, start over from A.
STEP :: 07

PROGRAM THE SYSTEM FOR TWO OR THREE-DOG OPERATION

SportDOG® Add-A-Dog® extra Collar Receiver(s) must be purchased to train additional dogs.
Please refer to the back cover for compatible Add-A-Dog® extra Collar Receivers for this system .
1. Program the Remote Transmitter to mode 3 or 4 (see STEP 05).
2. Program the first Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal
flashing. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
flashes 5 times. If the Receiver Indicator Light does not flash 5 times, start over from A.
3. Program the second Collar Receiver using A through D above, but using the Lower Button in place of
the Upper Button.
4. Program the third Collar Receiver using A through D above, but using the Side Button in place of the
Upper Button.
SPORTDOG.COM 13