Match The Collar Receiver And Remote Transmitter; Program The Collar Receiver For Two Or Three-Dog Operation - SportDOG SportTrainer SD-1225E Manuel D'utilisation

NOTE: Modes 1, 2, 3, 4, 5 and 7 provide 8 levels of stimulation, which correspond to the setting of the Intensity Dial.
Mode 6 provides more "increments" to choose from – a total of 16 levels of stimulation. For example, in
mode 6 with the Intensity Dial set at 2, the lower button provides level 3 of 16 and the upper button provides
level 4 of 16.
† The +2 Boost sends a signal to the collar to issue a correction that is 2 levels higher than the
currently selected level. The system will not correct higher than level 8.
* After selecting mode 6 and while the green indicator light is still solid in colour, turn the intensity
dial to the desired Continuous Stimulation level and press the side button to set the level. The
green light will quickly fl ash acknowledging your selection. For example, if you turned the intensity
dial to 3, the side button on your Remote Transmitter will transmit Continuous Stimulation at level 3
when pressed. If no level is selected after 15 seconds, it will default to level 8.
____________________________________________________________________________

MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER

To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a new Collar
Receiver to work with your existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 5-6
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin fl ashing as
normal. If this occurs, start over and repeat from 1.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light fl ashes 5
times. You may need to hold both units 60 cm-90 cm (24"-36") from each other before this occurs. Once
the Receiver Indicator Light has fl ashed 5 times, the Collar Receiver has been reset and will begin
fl ashing as normal. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat from 1.
____________________________________________________________________________

PROGRAM THE COLLAR RECEIVER FOR TWO OR THREE-DOG OPERATION

A SportDOG
mode. Please refer to the Accessories section on page 13 for the compatible Add-A-Dog
Receiver for this system.
1. Program the Remote Transmitter to mode 3 (see page 11).
2. Program the fi rst Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its
normal fl ashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light fl ashes
5 times. You may need to hold both units 60 cm-90 cm (24" - 36") from each other. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat from A.
3. Program the second Collar Receiver using A through D above, but using the Lower Button in place of
the Upper Button.
4. Program the third Collar Receiver using A through D above, but using the Side Button in place of the
Lower Button.
12
® ®
Add-A-Dog Collar Receiver must be purchased to train a second dog in two-dog
WWW.SPORTDOG.COM
®
Collar