Manually Configure Remote Beeper; Set Tone And Run Mode - SportDOG SPORTTRAINER ADD-A-BEEPER Mode D'emploi

manually confIgure remote Beeper

Set tone and run mode

The Remote Beeper can only be programmed remotely from the SportTrainer® SD-1875/
SD-1875E Remote Transmitter (see SD-1875E Operating Guide for instructions). If you have
an SD-1825, SD-1825CAMO, or SD-1825E system, you can also set tone and Run Mode from
the beeper itself.
1. Turn the Remote Beeper off.
2. Press and release the On/Off Button to turn on the Remote Beeper.
3. Within 5 seconds press and hold the On/Off Button. The Remote Beeper will begin to cycle
through the 9 available tones.
4. When the desired tone is heard, release the button before the next tone starts. Tone is now set.
5. Press and hold the On/Off Button immediately following tone selection completion until
the number of beeps matches the desired Run Mode as shown in the chart.
1 Beep (Silent)
2 Beeps (5 second)
3 Beeps (10 second)
6. Release the On/Off Button after the corresponding number of beeps matches your desired Run Mode.
6
No beep when dog is running/Beeps once per second when dog is on point
Beeps every 5 seconds when dog is running/Beeps once per second when
dog is on point
Beeps every 10 seconds when dog is running/Beeps once per second
when dog is on point
WWW.SPORTDOG.COM