FUAVE SV9010 Mode D'emploi page 14

Installing the front guard
8. Align the hook of front guard with the marked spot at the top of rear
guard. Match front and rear guards, insert in order from top to bottom (all
the way around). Engage the clip to fix the front and rear guard as shown
in the figure and fix with screw.
How to adjust the height of slide pipe
• Press the height adjustment button to release the lock and enable to
adjust the height of slide pipe.
Attention:
• Make sure to fix the slide pipe before carrying.
• When you have difficulty in raising up the slide pipe
or pressing the height adjustment button, once push
down the pipe, then press the button and raise the
pipe.
How to adjust the vertical wind direction by hand
• Adjust to the desired angle with grasping the main
body, holding the handle and oscillating up and down.
USE
On/off button
• Each press of the button will switch to on or off.
• After connect to the power supply, the fan will be in standby mode,
press the on/off button, the fan starts operation at level 3 (speed of
level 3 is displayed on the LED display window).
• Memory function:
– When fan stops and you press the on/off button, the fan starts
operation at the previous setting of speed and swing mode.
– When completely unplugged, memory will be deleted.
Speed adjustment button
• Turn the speed adjustment button to choose the desired speed
between 1 and 24.
77.772820.01.001_77.772821.01.001_IM.indd 11 77.772820.01.001_77.772821.01.001_IM.indd 11
1 1
17-11-2020 12:43:18 17-11-2020 12:43:18