BH FITNESS H775RBM Instructions De Montage Et Utilisation page 12

IMPORTANT SAFETY ADVICE.-
PRECAUTIONS.-
This bicycle has been designed and constructed to
provide maximum
precautions should be taken when using exercise
equipment. Read
assembling and using the bicycle. The following safety
precautions should also be observed:
1 Keep children away from this equipment at all times.
DO NOT leave them unsupervised in the room where
this bicycle is kept.
2 It can only be used by one person at a time.
3 If you experience dizziness, nausea, chest pains or
any other symptom while using this appliance STOP
the exercise. SEEK
IMMEDIATELY
4 Use the appliance on a level, solid surface. DO NOT
use the bicycle outdoors or close to water.
5 Keep your hands well away from any of the moving
parts.
6 Wear clothing suitable for doing exercise. Do not
use baggy clothing that might get caught up in the
bicycle. Always wear running shoes or trainers when
using the machine. Make sure all laces/cords are tied
correctly.
7 This appliance must only be used for the purposes
described in this manual. DO NOT use accessories
that are not recommended by the manufacturer.
8 Do not place sharp objects near the machine.
9 Disabled people should not use the machine without
the assistance of a qualified person or a doctor.
10 Do warm up stretching exercises before using the
equipment.
11 Do not use the bicycle if it is not working correctly.
Caution: Consult your doctor before beginning to
use the bicycle.
important for those over 35 or suffering from
health problems.
Keep these instructions safe for future use.
GENERAL INSTRUCTIONS.-
Carefully read through the instructions contained in
this manual. It provides you with important information
about assembly, safety and use of the machine.
1 This unit has been designed for professional use.
The weight of the user must not exceed 180 kg.
2 Parents and/or those responsible for children should
always take their curious nature into account and how
this can often lead to hazardous situations and
behaviour resulting
circumstances should this appliance be used as a toy.
3 The owner is responsible for ensuring that anyone
who uses the machine is duly informed about the
necessary precautions.
safety. Nevertheless,
the whole manual
MEDICAL ATTENTION
This advice is especially
in accidents. Under
English
ASSEMBLY INSTRUCTIONS.-
For the assembly of this unit, we recommend the
help of a second person.
certain
Take the unit out of its box and make sure that all of
the pieces are there (Fig. 1)
before
1.(1) Main body; (48R) Right pedal marked with letter
(R); (53L) Left pedal marked with letter (L), (55) Main
post, (56) Post bottom cover, (57) Handlebar; (58)
Monitor; (133) Front cover; (132) Rear cover; (71)
Front stabiliser bar; (73) Rear stabiliser bar; (74) Rear
trim, (79) Support, (145+146) Backrest; (96) Saddle;
(138+139) Tray; (97) Adapter.
Hardware pack containing:
(65) Washer D8,5xD16; (61) Screw M5x15; (64) Screw
M8x15; (94) Screw D4x15; (75) Screw D4; Wrenches.
2. Take the front stabiliser
position it as shown in Fig.2, insert bolts (64), fit the plain
washers (65), and tighten securely.
Take the rear stabiliser bar (73) and position it on the
machine's rear stand bracket support (1), as shown in
Fig.3, inserts bolts (64), fit the plain washers (65) and
tighten securely.
3. FITTING THE PEDALS.-
The assembly instructions for the pedals must be
followed to the letter, fitting these incorrectly could
damage the screw thread on either the pedal or the
crank.
Right and left refer to the position that the user adopts
when sitting on the saddle to do the exercises.
The right-hand pedal (48), marked with the letter (R),
screws onto the right-hand crank, also marked with an
(R), in a clockwise direction. Tighten securely, Fig.4.
The left-hand pedal (53), marked with the letter (L),
screws onto the left-hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten securely, Fig.4.
Once the pedals have been fitted, insert the end of the
pedal clip into the slot on the pedal adjusting it to your
footwear on the ledge of the pedal.
4. FITTING THE MAIN POST.-
Take the main post (55) and and fit the lower tray
(139) and the cover (56) as shown in Fig.5. Bring the
main post (55) up to boss on the main body (1),
connect the terminals, Fig.5.
Slip the main post (55) over the boss on the main
body (1), Fig.5, making sure not to snag any of the
cables.
no
Fit the screws (64), and the washers (65), Fig.5, and
tighten securely.
Lower the bottom trim section (56) for the main post
down over the boss section of the main body (1).
12
MOD. H775RBM
bar with wheels (71) and