Attach Cover; Battery Change On The Auto Ignitor; Specific Information; Disposal - Truma S 3004 Mode D'emploi

Attach cover

Suspend the cover (1) in the bottom bearing and pivot in (2)
until the lock audibly clicks into place. Check the tight fit by
pulling.
1

Battery change on the auto ignitor

If ignition sparks cannot be heard when commissioning or
only at intervals of more than one second, the battery needs
to be replaced.
Only change the battery with the heating system switched off.
Insert a new battery before the beginning of each heating sea-
son! Dispose of the old battery correctly!
Only use temperature-resistant (+70 °C), leak-proof mignon
batteries (LR 6, AA, AM 3) (part no. 30030-99200); other bat-
teries can cause function faults!
Remove the cover, slide the battery compartment cover up
and change the battery. Pay attention to positive/negative.
Close the battery compartment again. Put the cover back on.

Specific information

If the vehicle floor is provide with underbody protection, all
heating parts found under the body must be covered so that
the spray mist does not lead to functional faults. Remove the
covers again after finishing work.

Disposal

Dispose of the unit and the battery in the auto ignitor sepa-
rately as specified in the administrative regulations of the re-
spective country in which it is used. National regulations and
laws (in Germany, for example, the End-of-life Vehicle Regula-
tion) must be observed.
In other countries, the relevant regulations must be observed.
12

Technical data

(established according to EN 624 or Truma test conditions)
S 3004 / S 3004 P / S 5004
Gas type
Liquid gas (propane / butane)
Operating pressure
30 mbar (see type plate)
Rated thermal output
S 3004 / S 3004 P: 3500 W
S 5004:
2
Gas consumption
S 3004 / S 3004 P: 30 – 280 g/h
S 5004:
Additional information according to EN 624
S 3004 / S 3004 P: Q
S 5004:
Countries of destination
BE, BG, RO, DK, DE, EE, FI, FR, GB, UK, IS, IE, IT, LV, LT, LU,
MT, NL, NO, AT, PL, PT, SE, CH, SK, SI, ES, CZ, HU, CY
Operating voltage
1.5 V (automatic ignition device with battery compartment)
Current draw
225 mW (ignite)
Weight
S 3004 / S 3004 P: approx. 10.3 kg (without fan)
S 5004:

Dimensions

S 3004 / S 3004 P
S 5004
* with chrome decorative strip
** Truma Ultraheat (optional)
Dimensions in mm with tolerance + 2 mm / - 1 mm
The right to effect technical modifications is reserved!
6000 W
60 – 480 g/h
= 4,0 kW (Hs); 290 g/h; C
n
Q = 6,8 kW (Hs); 490 g/h; C
n
approx. 17.5 kg (without fan)
503*
500
102**
374
533*
530
102**
; I
51 3B/P
; I
51 3B/P
92*
281
90
122
122*
120
217