Troubleshooting - MAXXMEE 07227 Mode D'emploi

EN
Cleaning the Dust Container and
Filters
Please Note!
■
Do not wet-clean the EPA fi lter!
■
Never assemble wet or damp com-
ponents or attach them to the motor
unit!
1. Empty the dust container (13), and
detach it from the motor unit (see
above).
2. For thorough cleaning, the dust
container can also be removed com-
pletely. To do this, lift up the release
button (11) and slide out the locking
catch.
3. Then slide the locking catch all the
way back into the recess and shut
the dust container until you hear it
engage.
4. Remove the metal fi lter (12) from the
dust container.
5. The EPA fi lter is located in the metal
fi lter. Remove the bottom cap and
pull off the metal fi lter.
6. Tap out all parts and clean them with
a soft brush if necessary.
7. Wipe out the dust container and met-
al fi lter with a damp cloth if necessary.
Let them dry completely in the air
before you reassemble them!
8. The device is assembled in the re-
verse order: Place the metal fi lter onto
the EPA fi lter. Place on the end cap
and insert into the dust container. In-
sert the dust container into the motor
unit (see above).
 
The EPA fi lter may lose some of
its colour over time. This is normal
and does not have any adverse
effect on function.
16
Storage
• Store the device in a cool, dry place
which is protected from direct sunlight
and is out of the reach of children and
animals.
• Plug the nozzles (3, 6) onto the nozzle
holders. (Picture J)

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not start.
The battery is empty.
► Charge up the battery.
Low suction force.
The battery is weak.
► Charge up the battery.
The dust container (13) is too full.
► Empty the dust container.
The fi lters (12) are dirty.
► Clean the filters.
The suction opening (15) is blocked.
► Switch off the device and remove the
blockage.
The dirt particles are too large or too heavy.
► Switch off the device and remove dirt
particles by hand.
Dust escapes from the device during
cleaning.
The dust container (13) or fi lters (12) are
not fi tted correctly.
► Correct the fi t of the dust container
and fi lters. Make sure that the dust
container is closed.