Use; Cleaning And Storage - MAXXMEE 07227 Mode D'emploi

Handheld Vacuum Cleaner

USE

Please Note!
■
Do not use the device if there is vis-
ible damage to the device or acces-
sories.
■
Ensure that there are no sharp objects
on the surface which is to be cleaned.
■
In the event of damage / faults, switch
the device off immediately.
■
Note the MAX marking of the dust
container and empty the dust contain-
er as soon as it is reached. Regularly
clean the fi lters to prevent the motor
from overloading (see "Cleaning and
Storage").
The process of detaching and attaching
the dust container (13) is described in
"Cleaning and Storage" – "Cleaning the
Dust Container and Filters".
1. Select a nozzle as required and plug it
into the suction opening (15):
○ The upholstery nozzle (6) is used for
vacuuming upholstery and textiles.
(Picture I)
○ The crevice and brush nozzle (3) is
suitable for places which are hard to
get to, such as corners, crevices or
recesses. (Picture G and H)
To turn the crevice nozzle into the
brush nozzle, simply fl ip the brush
forwards (Picture C and D).
○ The fl oor nozzle (7) is suitable for
cleaning larger areas. It can be used
both on carpet and on hard fl oors.
○ The extension tube (5) makes it
easier to clean fl oors and reach the
tops of cupboards, ceilings, corners
or radiators, for example. (Picture F)
The device can also be used without
an additional nozzle.
2. The device is operated using the
On / Off switch (16) as follows:
press 1 x: switch on suction level I
press 2 x: increase suction power (suc-
tion level II)
press 3 x: switch off
When the device is switched on, the
operating lamp in the On / Off switch
lights up blue.
3. Guide the suction opening / nozzle
over the surface to be cleaned. Switch
the device off after each surface
has been cleaned. This will increase
the operating time on each battery
charge.
4. After vacuuming, switch off the de-
vice, empty or clean the dust contain-
er (13) (see "Cleaning and Storage")
and charge up the battery (see
"Charging Up the Battery").

CLEANING AND STORAGE

Please Note!
■
Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories. They may damage
the surfaces.
• Wipe down the motor unit, the
nozzles (3, 6, 7), the extension tube
(5) and the charging station (1) with
a damp, soft cloth if necessary. Then
dry with a soft cloth.
• Regularly remove hair and fl uff from
the nozzles.
Emptying the Dust Container
1. Hold the device over an open dust-
bin. The distance from the dustbin
should be as small as possible so
that the dust does not spread in the
surrounding air.
2. Open the dust container (13): Press
the opening button (14). The dust
container fl ips open (Picture E). The
dirt which has been sucked up will
drop out.
EN
15