Cleaning And Storage; Troubleshooting - MAXXMEE 03605 Mode D'emploi

EN

CLEANING AND STORAGE

Please Note!
■
Do not use any sharp or abrasive
cleaning agents to clean the device.
They may damage the surfaces.
 
The fi lter may lose some of its
colour over time. This is normal
and does not have any adverse
effect on function.
1. Take off the accessory if it is located
on the device.
2. Press the release button (3) and take
the collecting container (12) off the
motor unit (5).
3. Remove the EPA11 fi lter (14).
4. Empty the collecting container over
an open dustbin or drain.
5. Tap out the EPA11 fi lter and clean it
with a soft brush if necessary. It can
also be rinsed out with clear water,
but it must be completely dry before
it is assembled!
6. Wipe the collecting container with a
damp cloth if necessary and then dry
it or allow it to dry in the air. Never
assemble wet or damp components!
7. Once all components are dry, insert
the EPA11 fi lter into the collecting
container and place it back on the
motor unit. It must engage audibly.
8. Remove hair and fl uff from the used
accessory.
9. Store the device and accessories in
a cool, dry place which is protected
from direct sunlight and is out of the
reach of children and animals.
 
To prevent a deep discharge of
the battery, charge it up every
3 months if it is not used for a
prolonged period.
14
03605_Inlay_de-en-fr-nl_A5_V1.indb 14 03605_Inlay_de-en-fr-nl_A5_V1.indb 14

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The battery is not charging. The con-
trol lamp does not light up.
The USB cable (8) is not connected
correctly to the device or the USB mains
adapter.
►
Check the connection and correct it.
The USB mains adapter is not inserted in
the plug socket correctly.
►
Correct the fit.
The plug socket is defective.
►
Try another plug socket.
The device does not start.
The battery is empty.
►
Charge up the battery.
Low suction force.
The battery is weak.
►
Charge up the battery.
The collecting container (12) is too full.
►
Empty the collecting container.
The EPA11 fi lter (14) is dirty.
►
Clean the filter.
The suction opening (13), the nozzle ( 7,
10) or the extension hose (9) is blocked.
►
Switch off the device and remove the
blockage.
The dirt particles are too large or too
heavy.
►
Switch off the device and remove dirt
particles by hand.
07.04.2021 16:45:40 07.04.2021 16:45:40