Leuze BCL 600i Mode D'emploi page 18

EN
Laser safety notices
ATTENTION, LASER RADIATION – CLASS 2 LASER
PRODUCT
Do not stare into beam
The device satisfies the requirements of IEC/EN 60825-1:2014 safety
regulations for a product of laser class 2 and complies with 21 CFR
1040.10 except for conformance with IEC 60825-1 Ed. 3., as described
in Laser Notice No. 56, dated May 8, 2019.
 Never look directly into the laser beam or in the direction of reflected
laser beams!
If you look into the beam path over a longer time period, there is a
risk of injury to the retina.
 Do not point the laser beam of the device at persons!
 Interrupt the laser beam using a non-transparent, non-reflective
object if the laser beam is accidentally directed towards a person.
 When mounting and aligning the device, avoid reflections of the laser
beam off reflective surfaces!
 CAUTION! Use of controls or adjustments or performance of proce-
dures other than specified herein may result in hazardous light expo-
sure.
 Observe the applicable statutory and local laser protection regula-
tions.
 The device must not be tampered with and must not be changed in
any way.
 There are no user-serviceable parts inside the device.
Repairs must only be performed by Leuze electronic GmbH + Co.
 The bar code reader emits a moving laser beam that scans with a
beam spread of 60°. Here, the laser is operated in CW mode. A scan-
ning laser beam in CW mode creates the perception of repeating
laser impulses if you inadvertently look into the beam. At a distance
of 60 mm from the exit window, pulse durations <150 µs with a pulse
power of 2 mW would be received by the eye of the observer. The
mean laser power is <1 mW and the wavelength is 405 nm. See
also
18
on Page 3.
1