Publicité
Les langues disponibles
Les langues disponibles
If activated by DIP3=ON, it permits to select speed during the motor braking phase:
1 With motor stopped, preset Dip-switch DP1 to the desired speed, as shown in the table beside.
2 Press button P1, wait that LED PROG switches off.
The braking speed is not preset.
3 Move the dip-switches to the previous position.
ON
1
5 6 7 8
���
���
It allows to select the duration in seconds of braking, following the limit switches activation. The default value
is set to 3 seconds.
1 With motor stopped, preset Dip-switch DP1 to the desired speed, as shown in the table beside.
2 Press button P1, wait that LED PROG switches off.
The braking time is now preset.
3 Move the dip-switches to the original position.
ON
1
6 7 8
���
��� �
ON
1
6 7 8
��� �
The delay function can be deactivated in the opening (TRAP) and closing (TRAC) phases by proceeding as
follows:
Deactivation :
1 Move Dip-switch 1 of the selector switch DP1 to OFF, all others to ON.
2 Press button P1, wait that LED PROG switches off.
3 Move the Dip-switches to the original position.
Activation :
1 Move Dip-switches 2-3-4 of the selector switch DP1 to ON, all others to OFF.
2 Press button P1, wait that LED PROG switches off.
3 Move the Dip-switches to the original position.
4
Time preset with trimmer TRAC and dip-switch 4 TRAP is thus reset.
The control unit provides testing of the power circuit good conditions (TRIAC).
The unit comes factory-adjusted with this function disabled.
This test function can be enabled or disabled as follows:
To enable the test function to check the power circuit good conditions:
1 Move Dip-switches 3-5 of the selector switch DP1 to ON, all others to OFF.
2 Press button PGM, wait that LED PROG switches off.
4 Move the Dip-switches to the original position.
5 With function activated, should a failure in the power circuit occur or in case of faulty thermal switch in the
motor, all LED's of the "Power" band will start flashing. The control unit will execute no control.
10
To preset the braking speed
ON
10
1
5 6 7 8
10
To preset the braking time
ON
10
1
6 7 8
��� �
ON
10
1
6 7 8
��� �
TRAP/TRAC deactivation
To check the good conditions of the power circuit
ON
ON
1
5 6 7 8
10
1
ON
10
1
��� �
ON
1
10
��� �
ON
5 6 7 8
10
1
ON
6 7 8
10
1
ON
6 7 8
10
1
5 6 7 8
10
���
6 7 8
10
��� �
6 7 8
10
��� �
Publicité
