Publicité
Troubleshooting
PROBLEM
No sound or faint
Transmitter POWER light off
sound
Receiver POWER light off
Receiver A/B lights on
Receiver A/B lights off
Transmitter and receiver
POWER lights glowing
Receiver A/B lights on
Transmitter Audio Peak
light on
Transmitter LOW BATTERY
light on
Distortion or unwanted
Receiver A/B lights on
noise bursts
Receiver A/B lights on
Transmitter Audio Peak
light on
Distortion level
Transmitter LOW BATTERY
increases gradually
light on
Sound level different
Receiver A/B lights on
from cabled guitar or
microphone, or when
using different guitars
Signal loss as
Receiver A/B lights off when
transmitter moves
signal is lost
around performing
area
INDICATOR STATUS
• Slide transmitter POWER switch to ON.
• Make sure battery is inserted properly (+/- battery terminals must
match transmitter terminals).
• Insert fresh battery.
• Make sure AC adapter is securely plugged into electrical outlet and
into DC input connector on rear panel of receiver.
• Make sure AC electrical outlet works and supplies proper voltage.
• Slide transmitter MUTE switch to ON.
• Increase transmitter gain until Transmitter Audio Peak light flashes
on loud peaks.
• Turn up receiver volume control as necessary.
• Extend receiver antennae vertically (T4A).
• Move receiver away from metal objects.
• Maintain line of sight between transmitter and receiver.
• Move transmitter closer to receiver.
• Check that receiver and transmitter are using the same frequency.
• Turn up receiver volume control.
• Check cable connection between receiver and amplifier or mixer.
• Replace transmitter battery.
• Remove or turn off nearby sources of RF (such as other wireless
systems, CB radios, CD players, computers, digital effects, etc.).
• Use a wireless system that operates on a different frequency.
• Reduce transmitter gain.
• Replace transmitter battery.
• Reduce transmitter gain.
• Replace transmitter battery.
• Adjust transmitter gain and receiver volume as necessary.
• Reposition receiver and perform walk-through test. If audio dropouts
persist, locate "dead" spots and avoid them during performance.
SOLUTION
17
Publicité
