Busch+Müller Line Brex Notice D'utilisation page 12

5. Package content
Rear light with assembly bolts | Fastening nuts | Instruction Manual
6. Assembly
Attach the rear light to the rack using the two fastening bolts on the rear and the enclosed fastening
material. The rear light is designed for a 50 mm assembly dimension. Tighten the screws only to the
extent preventing the rear light from slipping or falling off. BREX works without electrical connection to
the brake lever.
!
Align the rear light so that it is perpendicular to the ground and parallel to the colour track as shown
in the sketch opposite. This is absolutely necessary for the correct function of the stoplight!
No overhead mounting: The rear light must be above the Z-reflector to ensure that the rear light
1 2
is not mounted upside down.
Important: Lighting equipment must not be concealed at any time.
7. Power supply
Rear light exclusively for connection to a DC voltage source of 6 to 50V ( ) e.g. e-bike battery.
AC DC
Connection to an AC voltage source (e.g. dynamo) is not permitted! When connecting to an e-bike battery
or to a headlight with DC output, use the plug contacts on the rear light and ensure correct polarity!
Connecting this rear light is only permissible to vehicles that ensure power is still available to supply the
lighting system for at least 2 hours after the battery has switched off due to discharge.
12