General Cleaner Operation - Polaris Alpha iQ Manuel Du Propriétaire

2. Grip the notched end of the floating power
cable, insert into the control box, and turn
clockwise to tighten. (Figure 11.)
3. Plug the control box directly into a GFCI
outlet. DO NOT use an extension cord.
X
Figure 11. Connect Floating Cable
NOTE: To avoid damaging the power cable, do not
try to twist the entire cable housing (see below).
X
NOTE: To avoid exposing the power cable
connector pins to water, be sure the connector is
screwed in all the way and there is no gap. (see
below).
X
X
X
X
4
General Cleaner
Operation
CAUTION
To prevent damage to the cleaner, be sure to
adhere to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed.
• Store on the caddy out of direct sunlight or
inclement weather.
• Never lift the cleaner out of the pool by the
floating cable. Always use the lift feature to
remove cleaner from the pool.
• Take additional care when lifting the cleaner out
of the pool. It becomes heavier when filled with
water.
• Always remove the cleaner from pool when super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
X
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning
cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner
from the pool.
• Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
The Polaris robotic cleaner includes a safety
feature that automatically stops the cleaner if it is
powered on but not submerged in water. For pools
equipped with a beach area, this safety feature is
programmed to drive the cleaner in reverse and
back into the pool when the impeller is out of the
water.
Page 9