Section 4. Operation; Submerging The Cleaner; Operating The Cleaner - Polaris 9300 Sport Manuel Du Propriétaire

Section 4. Operation

4.1 Submerging the Cleaner

1. Submerge the cleaner in the pool and remove any
air trapped inside by keeping the unit vertical.
Refer to Figure 13.
1
Figure 13. Submerge the Cleaner Vertically
2. Ensure the unit sinks to the bottom of the pool.
Refer to Figure 14.
2
Figure 14. Cleaner on the Bottom of the Pool
3. Spread out the floating cable over the pool,
ensuring there are no kinks or coils in the cable.
Refer to Figure 15.
Figure 15. Spread Floating Cable Over the Pool

4.2 Operating the Cleaner

Select either the Cycle I or Cycle II cleaning program
on the power supply:
Cycle I Program
• Completed in 1.5 hours
• Maximum coverage in
minimal time
1. To start your 9300 Sport cleaner, press the button
for "Cycle I" cleaning program. "Cycle I" cleaning
is the primary cleaning cycle for inground pools. If
an alternative cycle is preferred, press "Cycle II".
Refer to Figure 16. The indicator light illuminates
and the cleaner starts up after just a few seconds.
When the cleaner is powered ON it will remain in
standby until the Cycle I button is pressed.
Figure 16. Start the Cleaner
2. When the "Cycle I" program button is selected the
indicator light above will illuminate. The cleaner
will start in a few seconds.
3. To change the selected cleaning cycle, press the
new cycle button and the new cycle will start in a
few seconds.
4. If you wish to stop the cleaner during a cleaning
cycle, press the OFF button. Refer to Figure 17.
5. At the end of the cycle, the cleaner will stop and
after 15 minutes the light will flash slowly to
indicate the cycle is completed.
6. The 9300 Sport includes a safety feature that
automatically stops the cleaner after about 20
Figure 17. Turn Cleaner Off
Page 9
Cycle II Program
• Completed in 2.5 hours
• Intensive and complete
cleaning
• Thorough tile cleaning